iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&ANMEA serial port Baud rate (Founded, got to select CUSTOM)NMEA serial port Baud rate (Founded, got to select CUSTOM)
Previous
 
Next
New Post
2/20/2021 1:43 PM
 

Hi all..

Trying to connect my TRIO Ap which needs 4800 Baud.

I'm seeing my NMEA controller and sentences are sent at 9600, must be a default.

Anyhow,, If I select serial port I'm not seeing anything just an empty box shows up,, no port or any baud rate selection???.

 

Regards

 
New Post
2/20/2021 6:31 PM
 

My Trio accepts the 9600 baud just fine. It states such in the newest manual (although hard to find) and I verified via phone call when I was setting mine up.

Best,

John

 
New Post
2/20/2021 8:49 PM
 

4800 or 9600 i'm still seeing NOGPS as opposed to FLTPLAN?????

I'm sure I saw it at some point, I must be missing something obvious again...

Regards

 
New Post
2/23/2021 3:28 PM
 

Easiest way to test it is to go set up a flight plan, then auto-fly it with everything plugged in. 

Then go to menu/about/connected devices. Should show NMEA output controller. That will show you're connected.

Then, go to menu/setup/NMEA Output to edit settings there!

 
New Post
2/23/2021 3:36 PM
 

Thx Brolin,,,,  I had that and seeing the controller. I was using the ground on Pin 6 instead if Pin5.

All is good now.  Cheers

Hope you are OK with the weather you're getting.

 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly Owners Q&AiFly Owners Q&ANMEA serial port Baud rate (Founded, got to select CUSTOM)NMEA serial port Baud rate (Founded, got to select CUSTOM)