iFly GPS Forum

We have a new Forum!  Go here to get started: https://adventurepilot.community.forum.  
The new forum is easier to use and much more capable than the old, we hope you will join our community! 

Below is a copy of the old forum. This will remain available for a short period so you can access and review the information contained here. To continue a conversation, or start a new one, please register and create a post at our new forum location.
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...ADS-B Traffic with NavWorx ADS600ADS-B Traffic with NavWorx ADS600
Previous
 
Next
New Post
11/21/2011 8:42 PM
 

I was at NavWorx the other day and we connected their ADS600-B to the iFly700 and it worked! ADS-B Traffic was shown on the iFly! Very neat.. Granted this wasn't a comprehensive test, but it did show that the interface protocol seemed to work. Since the ADS600-B has the "out" feature I have one on order....

 
New Post
11/22/2011 1:36 AM
 

Hi Dick,

What was needed to connect the two (is it the standard USB to serial found on the "shop" site)?

Regards,
Neal

 
New Post
11/22/2011 10:45 AM
 

Hi Neal,

Yes, that is what we used.

Dick

 
New Post
11/29/2011 8:57 AM
 
I'd also like to hook up my ADS600B. what ifly pin number is used to get that info into the Ifly700?

Roger
 
New Post
11/29/2011 3:52 PM
 
revenson wrote:
I'd also like to hook up my ADS600B. what ifly pin number is used to get that info into the Ifly700?

Roger


Pin 2 is the serial input to the iFly, according to phone call to iFly this morn. Also wrote Navworx to confirm that same serial setup used for GRT should work for iFly. Will try it tomorrow.
Roger.


Update: Worked fine for traffic...didn't check weather.
 
Previous
 
Next
HomeHomeDiscussionsDiscussionsiFly General Di...iFly General Di...ADS-B Traffic with NavWorx ADS600ADS-B Traffic with NavWorx ADS600